Watch This Video Tutorial to Get Started
Before you begin, you'll need
Your Strike Go ring
Phone with NFC enabled
The Strike Go app here
A Visa or Mastercard ready to add
For the smoothest pairing, remove your phone case and keep both your phone and ring steady. The NFC zone sits near the top-back left corner of most iPhones, on Android it varies by model.
Step 1 — Open the app
Launch Strike Go and select Wearables.
Step 2 — Start setup
Tap Set Up Strike Go, then Proceed. Hold your phone close to the ring.
Step 3 — Pair the ring
When your ring appears in the app, tap Finish Setting Up Now. Tap Proceed twice, then hold your phone steady against the ring to scan it.
Step 4 — Confirm your email
Check the email address shown is correct, then tap Next.
Step 5 — Add your card
Enter your card details and tap Next. Agree to the Terms of Service.
Step 6 — Write the card to your ring
Place your ring near your phone again. Hold steady — it can take a few moments to complete.
Step 7 — Verify with your bank
Activation varies by bank. You'll either receive an SMS code or be asked to approve the activation inside your banking app. Enter the activation code and tap Next.
Step 8 — Check Ring Status
Under the wearable you will see "status:" make sure it says "active"
You're set
Your card is now on your ring. Tap any contactless terminal to pay.